Step 2-2: Establish the Maximum Number of Phones Allowed to Registerīefore any IP phones can register with the system, the maximum number allowed to register must be set. RtrPodx(config-telephony)# no auto-reg-ephone Versions of CUCME prior to 4.0 (IOS Release 12.4(9)T) don’t have this command, so if you are using anĮarlier version, make sure to double-check the MAC addresses of the phones when registering them. Disabling autoregistration eliminates this problem. Problems if MAC addresses are entered incorrectly. However, allowing phones to autoregister can cause ![]() Step 2-1: Disable Auto Phone Registrationĭisabling autoregistration of phones is an optional step. Settings that must be configured (four in older versions of CUCME) before phones can register, and one optional setting that avoids Telephony-service configuration mode is where settings that impact the entire CUCME system are configured. Connect a PC to the switch and verify that it can ping the router and However, do not connect the phones to the switch until later. If necessary, load the configuration for both the switch and router. This lab is based on the configuration from either Lab 3-1 or 3-2.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |